Vehicle Blowers

Vehicle Blowers, Bulk Vehicle Blower

Bulk Vehicle Blower

We are offering to our clients, bulk vehicle blowers which are widely used for installation on any bulk material tanker trucks and portable industrial vacuum systems. Manufactured as per the industrial standards, these find their application in industries like Petrochemical, Pharmaceutical, Aeronautical, Cement and Chemical.

Intake Volume Flow	From 600 m³/h to 2250 m³/h.
Pressure Operation	Up to 1000 mbar or 1200mbar peak pressure.
Vacuum Operation	Down to -500 mbar g.
Medium conveyed	Air.
General Application	Mobile pneumatic conveying.

Aerzen Bulk Vehicle Blowers are manufactured in two- and three-lobe design and usable for conveying of air. Intake volume flow approx. 600 up to 2.250 m³/h.

Intake volume flow	:	approx. 600 up to 2.250 m³/h
Size	:	4
Suitable for	:	conveying of air
Pressure operation	:	up to max. 1000 mbar or 1200 mbar peak pressure
Suction operation	:	up to max. -500 mbar

Design with 3-lobe rotors :
Cylinder with cast-in pre-inlet channels at discharge side to minimize the sound by pulsation reduction. Therefore only vertical installation position is possible. Speed range between 1450 up to 4800 1/min.
Oil splash lubrication with oil sight glasses on both sides.

Shaft sealings :
Conveying chamber by the carbon ring labyrinth seal proven over decades in connection with the neutral chambers open to the atmosphere. Driving shaft with radial seal ring.

Direction of flow :
vertical, from top to bottom

Design: with two-lobe rotors :
The conveying chamber is completely separated from the oil sumps by a space open to atmosphere.
The machine can be positioned upright, suspended from the top, and suspended from the left or right.
They are also available with an integrated gearbox with a speed set-up ratio of i=2,1.
The operating speed range is 1350 to 3200 1/min.
The drive side is grease lubricated, while the gear side is splash oil lubricated.
Gear driven models feature splash oil lubrication on both sides. Oil level check by means of dipstick.

Shaft sealings :
The conveying chamber is sealed by means of four piston rings in combination with oil slingers adjacent to the vent space.
The drive shaft is sealed by a seal ring. Gear driven models are sealed by a radial seal ring.

Direction of flow :
Both directions possible in horizontal or vertcial flow.

Drive:
Via direct coupling or narrow v-belt drive.

Special materials :
None available.

Delta Blower Generation 5 : Delta Blowers Generation 5 | Delta Screw Generation 5 |

Vacuum Pumps : High Vacuum Pumps | Vacuum Blower With Pre-Inlet Cooling | Low Vacuum Blower ( Pump ) |

Screw Compressors : Oil Free Air Compressors | Oil Free Gas Compressors | Oil Flooded Screw Compressor |

Address : Aerzen Machines (India) Pvt. Ltd. : Plot No. E-115 / 116, G.I.D.C Savli, Tal. Savli, Dist. Vadodara - 391 775, Gujarat, India.

Phone.: +91-2667-264 816 / 264 817 , Fax.: +91-2667-264 818 , E-mail.: response@aerzenindia.co.in

Home I Profile I Contact I Enquiry |